Spa Heater Element Hot Tub Heating Coil 5.5kw M7 Universal 9.8", W/ Gaskets

Spa Heater Element SIDE Terminals Style, Flo-Thru Hot Tub Heating Coil 5.5kw 230/115v, new side terminal Flo-Thru heater element, Incoloy 800 sheath, Stainless bulkhead fittings, large sealing o-rings, bulkheads are epoxy sealed on the backside too. Rated 240 volts 5.5kw AND 120 volts 1.375kw Heater housing gaskets (2) included. Compatible with Balboa M-7 type heaters, where the overall length must be 9.9" or less and must have the correct terminal placement. Certified, guaranteed good resistance and thorough ground fault tested, prior to shipping. Over 31 electrical tests performed.

Includes 2 new heater housing gaskets, standard size for flanged 2.25" outside diameter stainless steel flo-thru heaters, in translucent Santoprene elastomer. Ships from Spa Pumps And More. Includes installation startup instructions (VERY important). Can be run on 230v as 5.5kw (5500 watts) or on 115v 1.375kw (1375 watts), fits many flo-thru heaters requiring side terminals, Balboa M-7, Gecko, Acura controls as well as Morgan, Brett, and many others. Includes an installation guide with tips on proper heating element startup.

Sized for 2.25" diameter flo-thru heater housings with 1-1/4" terminal spacing, with 1/2" bulkhead holes in housing, these are all very common, standard dimensions. Overall length of this element is approximately 9-3/4". American made and ships from the U.S. Not from china. High quality.

Not for housings smaller than 2.25" outside diameter, not for terminal spacing other than 1-1/4", not for hole size other than 1/2" terminal holes in housing, and not for replacing elements with centered terminals, please note. If you have a need for some other style or size, message us with those details please. For a proper fit you need your heater housing to conform to the details listed which again are: Stainless Steel Housing outside diameter must be 2.25" (2-1/4 inch) Housing hole size for terminals must be 1/2 inch. Housing hole spacing must be 1-1/4 inch center to center. Housing must require an element with terminals offset to one side.

Housing must require an overall element length of approximately 9-3/4 inch. Ground shipping is included in the cost. Thanks for looking! Questions, message us please, we are here to help :)