Spa Heater Element 5.5 Kw Hot Tub Heating Coil 5.5kw M7 Universal 9.8" Gaskets

Spa Heater Element SIDE Terminals Style, Flo-Thru Hot Tub Heating Coil 5.5kw 230/115v, new side terminal Flo-Thru heater element, Incoloy 800 sheath, Stainless bulkhead fittings, large sealing o-rings, bulkheads are epoxy sealed on the backside too. Rated 240 volts 5.5kw AND 120 volts 1.375kw Heater housing gaskets (2) included. Replaces 12-0111-k, 6-flo, element for 58083, 347PM-5i, and others Compatible with Balboa M-7 type heaters, where the overall length must be 9.9" or less and must have the correct terminal placement. Certified, guaranteed good resistance and thorough ground fault tested, prior to shipping. Over 31 electrical tests performed.

Includes 2 new heater housing gaskets, standard size for flanged 2.25" outside diameter stainless steel flo-thru heaters. Color varies from silver to dark gray. Not for saltwater, for freshwater use at pH 7.3-7.4 Want a 'better' element? Look at our 5.0kW element, the best element you can get, draws 10% less amps than a 5.5kW, so is easier on your motherboard relays, and gets the water just as hot as any 5.5kW would. Tends to last longer too as it runs a bit cooler internally than any 5.5kw.

P/n 624502. Ships from: Spa Pumps And More Ground shipping is included in the cost. Thanks for looking! Questions, message us please, we are here to help :) Includes startup instructions (VERY important). All 5.5kW elements run very hot, so this is critical: Please be very careful on startup procedure, do NOT put power to the heater until after the pump has run a good 20 minutes or more on high so all air is out of the system!!

In other words, do not turn up the temperature until you run the pump 20 mins on high speed by pressing the jets button. Can be run on 230v as 5.5kw (5500 watts) or on 115v 1.375kw (1375 watts), fits many flo-thru heaters requiring side terminals, Balboa M-7, Gecko, Acura controls as well as Morgan, Brett, and many others. Includes an installation guide with tips on proper heating element startup. Sized for 2.25" diameter flo-thru heater housings with 1-1/4" terminal spacing, with 1/2" bulkhead holes in housing, these are all very common, standard dimensions. Overall length of this element is approximately 9-3/4".

Ships from California. High quality. Not for housings smaller than 2.25" outside diameter, not for terminal spacing other than 1-1/4", not for hole size other than 1/2" terminal holes in housing, and not for replacing elements with centered terminals, please note. If you have a need for some other style or size, message us with those details please. For a proper fit you need your heater housing to conform to the details listed which again are: Stainless Steel Housing outside diameter must be 2.25" (2-1/4 inch) Housing hole size for terminals must be 1/2 inch.

Housing hole spacing must be 1-1/4 inch center to center. Housing must require an element with terminals offset to one side. Housing must require an overall element length of approximately 9-3/4 inch.