Aqua Finesse Deep Clean Spa And Hot Tub Tablet - Cleans The Parts You Can't!

AQUA FINESSE SPA CLEANING TABLET For use in your hot tub/spa as a ‘Deep Clean’ treatment the AquaFinesse Spa Clean Tablet product cleans thoroughly removing slime, grime and calcium from inside piping and pumps. Is your Spa in need of a deep clean? There are many reasons why this may be the case. If you are using traditional sanitiser's, or your spa has stood empty for some time slime, grime and calcium can firmly attach to the walls and pipe work within the system. Historically this has proven very difficult to remove, even when using the harshest of chemicals.

But it's no longer a problem; the AquaFinesse Spa Clean Tablet will thoroughly deep clean the system by loosening the ground on debris and calcium deposits from deep within the spa. *This product is also used very successfully as a deep clean for Whirlpool Baths. How to use AquaFinesse Spa Clean Puck - Hot Tubs & Spas Your Spa will need to be emptied every 3 months, this is the perfect time to use the AquaFinesse Spa Clean Puck to deep clean your pipework and surfaces. With the water still in the spa, open all valves, jets, blowers, water falls etc. (high water temperature is not necessary) Environmentally Friendly, Removes Slime, Grime and Calcium from your spa, it's pipe work and equipment.Perfect for: Instructions for use: - Hot Tubs 1.Raise the chlorine level in your spa to around 3ppm before beginning the deep clean process 2.Dissolve the Spa Clean Tablet by adding it directly to your spa water ensuring first that all jets and air valves are set on the open position.

3.Activate pumps on full power for 20 minutes to allow a good flow * 4.Repeat the pump activation process at least 2 - 3 times during the deep clean. Recommended treatment time is 12-24 hours. 5.Once the treatment is complete remove and clean filters, empty your spa and refill with fresh tap water, add a chlorine shock. 6.Resume maintenance with AquaFinesseTM hot tub water treatment Instructions for use- Whirlpool Baths 1. To save water you may add the Spa Clean treatment tablet directly to the water after bathing. 2.

Once dissolved, activate the jets and air blowers for a minimum of 10 minutes. 3. Leave the treated water in the bath overnight. 4. In the morning reactivate the jets for a 20 to 30 minute period. 5. Empty the bath and refill with fresh water and activate the jets once again. 6. For best results follow with the addition a Pure-Spa Whirlpool Sanitising tablet or a small amount of Spa chlorine granules (available separately - follow instructions on the pack) then rinse the pipe work thoroughly, you may use cold water if you wish. 6.

Your whirlpool bath has now been deep cleaned and is ready for use. Do not use the bath during the cleaning process. Your whirlpool bath should be deep cleaned following the above process every three months.See our classifieds board shop for more treatments and accessories for pools and hot tubs.